CRYSTAL EFFECT COMPOUND 2kg

The crystal-effect mass is an innovative, decorative mass, which, thanks to the content of special particles, creates a unique effect of crystal surfaces. The effect enhances its unique visual qualities with the use of appropriate illumination with artificial light, as well as under the influence of natural light. The mass gives the interiors a distinctive elegance with accents of luxury, which perfectly harmonizes with modern and glamor-style interiors.

- clearly accentuates the interior

- illuminates the decorated surfaces

- gives the interior a luxury in a glamorous style

The mass is intended for decoration of interior walls made of cement mortars, cement-lime mortars, plasterboards and other mineral surfaces. It is perfect for interiors in single and multi-family housing, clearly emphasizing the walls in rooms such as the living room, bedroom or hall. It also fits perfectly in public spaces, such as restaurants, hotels, discos, etc.

Also, remember to purchase dedicated primer

Primer Deco

TECHNICAL PARAMETERS

HOW TO USE

SUBSTRATE PREPARATION

The mass should be applied to seasoned, strong, durable, clean, dry and free of dust, grease and other substances reducing the adhesion of the substrate. Fresh cement and cement-lime plasters should be primed after approx. 4 weeks, and gypsum plasters after approx. 2 weeks from their implementation. Coats and surfaces made in drywall systems must be dusted and then primed with a primer, eg Fixgrunt U. It is important that no white dust remains on the hand after rubbing. The surfaces covered with emulsion paints with good adhesion should be washed with water with the addition of painting soap, rinsed with clean water and dried. Places covered with mold or fungus should be cleaned mechanically and disinfected with Biotox Total algae and fungicide. Before applying the mass, the surface should be thoroughly primed (1 - 2 times) with GUARDI white primer.

PRODUCT PREPARATION

Pour the entire contents of the sachet under the lid into a bucket of resin and mix thoroughly with a manual or mechanical mixer, distributing the crystal filler evenly throughout the entire volume.

HOW TO USE

Apply the mass with a steel trowel with rounded corners or a Venetian trowel, to the thickness resulting from the thickness of the filler in the product. The mass should be evenly distributed over the entire surface to be decorated, leaving no gaps, and then carefully smoothed with a steel trowel or putty knife. The final stage is to give a delicate structure to the mass, which is made with a paint roller with a fleece thickness of 8 - 12 mm. The temperature of the substrate and the environment during application should be between + 10 ° C and + 25 ° C. The mass can be applied after min. two hours from priming the substrate (at air and substrate temperature of approx. 20 ° C and air humidity of 55 ± 5%). Immediately wash the tools with water after finishing work.

ADDITIONAL INFORMATION

The mass should be stored in original and tightly closed packages. Protect against frost and sunlight. Storage temperature: from + 5 ° C to + 30 ° C. When applying the mass on surfaces previously covered with emulsion paints, adhesion tests should be performed. Before use, read the product's Technical Data Sheet. Ventilate the rooms until the odor disappears. The LAKMA SAT company is not responsible for the quality of the product and the final effect if the recommendations are not followed.